THE FUTURE OF CLEANROOM FILTRATION IS WM GEL TECHNOLOGY

WM Plastics manufactures two types of Cleanroom Filtration Gels to seal HEPA UPLA filters used in Cleanroom Filtration.. Both are urethane gels that are combined by two different methods, but the end results are the same. This section is dedicated to information that is common to both Easy Pour and Soft Seal Gels. Click on the links to the left for the specific information on Molecular Contaminants, Waste Disposal, Biological Fungal Growth, UV Rays, Compatibility, Temperature Range and Penetration.

Easy Pour Cleanroom Filtration Gel For HEPA UPLA Filters
Easy Pour Gel is our next generation “one part” urethane gel. The critical chemical balance needed to have a quality product is established during the manufacturing process, not at the job-site. Pour in a pre-measured container of Blue Activator, then thoroughly mix to initiate the cure. The tabs below contain additional information about the properties of Easy Pour Gel.
Read More
Soft Seal Cleanroom Filtration Gel
Soft Seal is a two-part urethane combined in a 1:1 ratio by weight or volume. This is a fast setting gel that allows filters to be set very quickly after pouring. Actual cure time depends on the ambient temperature of the room. As temperature increase, cure time decrease. It is important to maintain the 1:1 mix ratio as precise as possible, then thoroughly mix the Part A and Part B together.
Read More