Mixing





Part A and Part B must have matching lot numbers (cannot mix lot no.)
Soft Seal must be throughly mixed at a 1:1 ratio by weight or volume.
This can be done by hand, or with a precision metering equipment.
The device selected must be accurate to with in +/-2%. It is not recommended that the gel be poured below 60F.
The gel should be tested for proper curing before installation. We require this test before installation
 
    Procedure:
Place equal amounts of the combined material (by weight or volume) in a small metal container.
Stir the liquid throughly.
Apply heat using a hairdryer or heat gun for approximately 5 mins.
The materials should gel by his time, or be very thick, indicating it is good.


 

Copyright © 2017 WM Plastics Inc..
5301 Terminal Street
Charlotte, NC 28208
Toll Free: 800-535-4657
Local: 704-599-0511